What If Your Zorb Ball Is Broken (Part 1)

It is very common for inflatable products to break. So when you encounter this situation, you should not be nervous, you just need to use the right way to repair it.

Steps to repair your zorb ball

1.The first step in the repair of inflatable zorb ball (also know as human hamster ball) is to find out where the leak. First you need to check the air valve. Inflate the product with air fully, make the air valve up, and then pour a little water into the air valve to see if it bubbles. If there is bubbling, it is because the air valve is not properly fixed, so the air leaks. Just unscrew the air valve and then screw it back on again (be careful not to twist it crookedly)

2.If the air valve there is no air leakage, may be zorb ball is broken and have a small hole. The general volume of the product is relatively large after inflation, it is not possible to soak the product in water to check. So, at this time, you should first inflate the product with air (try to fill a little, if it can not enough swell, you can let another person to press the zorb ball with hand). Then test in order. According to past experience, the bottom is higher chance of being punctured by sharp objects, you can test from the bottom first, then the side, and then to the surface to test. Gently move your hand about 1cm from the surface of the zorb ball, if you move your hand to the place of the break, your hand will obviously feel the air sprayed out. Then remember the place of air leakage (you can use a pen to make a small mark).

Ending

If you want to buy a high quality zorb ball, you are welcome to buy it from Kameymall. As the picture shows, this is a zorb ball from Kameymall, it is red transparent. It is made of 0.8mm PVC, so it is hard-wearing and very waterproof, you can even use it on the water. Kameymall is always ready to welcome you.